This part of ISO 3310 specifies the technical requirements and corresponding test methods for test sieves of perforated metal plate.<\/p>\n
It applies to test sieves having<\/p>\n
round holes, with sizes from 125 mm down to 1 mm, or<\/p>\n<\/li>\n
square holes, with sizes from 125 mm down to 4 mm,<\/p>\n<\/li>\n<\/ul>\n
in accordance with ISO 565.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 6<\/td>\n | Foreword <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | Introduction <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | Section sec_1 Section sec_2 Section sec_3 Section sec_4 Section sec_5 Section sec_5.1 Section sec_5.1.1 1\tScope 2\tNormative references 3\tTerms and definitions 4\tDesignation 5\tPerforated metal plate 5.1\tRequirements <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | Section sec_5.1.2 Section sec_5.1.2.1 Section sec_5.1.2.2 Table tab_1 <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | Section sec_5.1.3 <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | Table tab_2 Section sec_5.1.4 Figure fig_1 Section sec_5.1.5 <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | Section sec_5.2 Table tab_3 Figure fig_2 5.2\tTest methods <\/td>\n<\/tr>\n | ||||||
| 13<\/td>\n | Section sec_5.3 Section sec_5.3.1 Section sec_5.3.2 Section sec_5.3.2.1 Section sec_5.3.2.2 Section sec_5.3.2.3 Section sec_6 5.3\tDocumentation for sieve conformity 6\tTest sieve frames <\/td>\n<\/tr>\n | ||||||
| 14<\/td>\n | Table tab_a Figure fig_3 Table tab_4 Section sec_7 7\tMarking of test sieves <\/td>\n<\/tr>\n | ||||||
| 15<\/td>\n | Annex sec_A Table tab_A.1 Annex\u00a0A \n(informative)<\/p>\n Test sieve record card <\/td>\n<\/tr>\n | ||||||
| 16<\/td>\n | Reference ref_1 Reference ref_2 Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Test sieves. Technical requirements and testing – Test sieves of perforated metal plate<\/b><\/p>\n |