Shopping Cart

No products in the cart.

BSI PD ISO/TS 11888:2017

$142.49

Nanotechnologies. Characterization of multiwall carbon nanotubes. Mesoscopic shape factors

Published By Publication Date Number of Pages
BSI 2017 26
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This European Standard applies to boilers used for central heating (heating boilers) with forced draught burners with a nominal heat output not exceeding 1 000 kW, which are operated either with negative pressure (natural draught boilers) or with positive pressure (pressurized boiler) in the combustion chamber, in accordance with the boiler instructions.

This European Standard specifies the necessary terminology, the requirements on the materials and testing of them, and marking requirements for heating boilers.

Particular requirements for boilers that can be used with open vented systems are contained in EN 303‑4 .

The requirements of this standard apply to heating boilers that are tested on an authorized test rig.

Boilers in accordance with this standard are designed for the heating of central heating installations in which the heat carrier is water, and the maximum allowable operating temperature of which is restricted to 100 °C. The maximum allowable operating pressure is 8 bar.

For boilers and water heaters (storage or continuous flow heater) this standard only applies to the parts which are necessarily subject to the operating conditions of the heating boiler (heating part).

This standard does not apply to gas boilers with atmospheric burners, boilers for solid fuels, boilers with oil vaporization burners. For these boilers there are further requirements.

PDF Catalog

PDF Pages PDF Title
2 National foreword
6 Foreword
7 Introduction
8 1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
3.1 Terms and definitions
10 3.2 Abbreviated terms
4 Sample preparation methods
4.1 Ball mill cutting
4.2 Dispersion method
4.3 Sample preparation for SEM
4.4 Alternative sample preparation method
11 5 Experimental procedure
5.1 Measurements of the SBPL using SEM
5.1.1 SEM
5.1.2 Measurement methods for the SBPL
12 5.2 Measuring inner and outer diameters of MWCNTs using TEM
6 Test report
13 Annex A (normative) Formulae for terms and definitions in Clause 2, Annex B, Annex C and Annex D
18 Annex B (informative) Viscometry
19 Annex C (informative) Dynamic light scattering and depolarized dynamic light scattering
21 Annex D (informative) Case study and reports
25 Bibliography
BSI PD ISO/TS 11888:2017
$142.49