BS ISO 11413:2019
$102.76
Plastics pipes and fittings. Preparation of test piece assemblies between a polyethylene (PE) pipe and an electrofusion fitting
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 18 |
This document specifies a method for the preparation of test pieces assembled from polyethylene (PE) pipes or spigot-ended fittings and electrofusion fittings (e.g. socket fittings such as couplers, or saddles).
The assembly criteria specified include parameters such as ambient temperature, fusion conditions, fitting and pipe dimensions, pipe configuration (coiled or straight pipe), taking into account the limiting service conditions specified by the relevant product standards.
This document can apply to other shapes, e.g. re-rounded pipes, dependent on the manufacturer’s instructions.
NOTE For the purpose of this document, PE is understood to be PE, PE-RT or PE-X.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 6 | Foreword |
| 7 | 1 Scope 2 Normative references 3 Terms and definitions |
| 8 | 4 Symbols 4.1 General symbols (see Figure A.1) |
| 9 | 4.2 Clearances 4.2.1 Socket fittings 4.2.2 Saddles 4.3 Ambient temperature 5 Joint assembly 5.1 General |
| 10 | 5.2 Procedure |
| 11 | Annex A (normative) Symbols for dimensions of an electrofusion socket |
| 12 | Annex B (normative) Diagrammatic representation of variation in fusion energy with ambient temperature |
| 14 | Annex C (normative) Conditions for the preparation of pipes and fittings |
| 15 | Annex D (normative) Determination of fusion-jointing electrical parameters using energy, voltage and current tolerances from ISO 12176‑2 |
Related products
-
BS ISO 11413:2019 – TC:2020 Edition
Tracked Changes. Plastics pipes and fittings. Preparation of test piece assemblies between a polyethylene (PE)…
