BS EN 13605:2013
$142.49
Copper and copper alloys. Copper profiles and profiled wire for electrical purposes
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 32 |
This European Standard specifies the composition, property requirements including electrical properties, and tolerances on dimensions and form for copper profiles and profiled wire for electrical purposes, which would fit within a circumscribing circle of maximum 180 mm diameter. The sampling procedures, the test methods for verification of conformity to the requirements of this standard, and the delivery conditions are also specified.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 8 | 1 Scope 2 Normative references 3 Terms and definitions |
| 9 | 4 Designations 4.1 Material 4.1.1 General 4.1.2 Symbol 4.1.3 Number 4.2 Material condition 4.3 Product |
| 10 | 5 Ordering information |
| 12 | 6 Requirements 6.1 Composition 6.2 Mechanical properties 6.3 Electrical properties 6.4 Freedom from hydrogen embrittlement 6.5 Drawings 6.6 Dimensions and tolerances 6.6.1 General |
| 13 | 6.6.2 Tolerances on cross-sectional dimensions 6.6.2.1 Profiles and profiled wires with a ratio bmax. or hmax. to smin. less than 20 : 1 shall conform to the requirements given in Table 5 (see Figure 2). 6.6.2.2 Profiles and profiled wires with a ratio bmax. or hmax. to smin. equal to or greater than 20 : 1 shall conform to the requirements given in Table 6 (see Figure 2). 6.6.2.3 The thicknesses of profiles and profiled wires shall conform to the tolerances given in Table 7. |
| 14 | 6.6.2.4 Radii, dimensioned in the drawing, shall conform to the tolerances given in Table 8. 6.6.2.5 The radii of sharp corners shall conform to the maximum values given in Table 9. 6.6.3 Tolerances on form 6.6.3.1 General 6.6.3.2 Twist 6.6.3.3 Flatness |
| 15 | 6.6.3.4 Perpendicularity and angularity 6.6.3.5 Deviation from circular form 6.6.3.6 Concentricity 6.6.3.7 Straightness |
| 16 | 6.6.4 Length of profiles 6.6.4.1 Tolerances on manufactured lengths 6.6.4.2 Tolerances on fixed lengths 6.7 Form of delivery of profiled wire 6.8 Mass tolerances 6.9 Surface condition |
| 17 | 7 Sampling 7.1 General 7.2 Analysis 7.3 Mechanical, electrical and hydrogen embrittlement tests 8 Test methods 8.1 Analysis 8.2 Tensile test 8.3 Hardness test |
| 18 | 8.4 Electrical test 8.5 Hydrogen embrittlement test 8.6 Retests 8.7 Rounding of results |
| 19 | 9 Declaration of conformity and inspection documentation 9.1 Declaration of conformity 9.2 Inspection documentation 10 Marking, packaging, labelling |
| 27 | Annex A (informative) Characteristics of coppers for electrical purposes A.1 General grouping of copper types A.2 General characteristics A.3 Particular characteristics |
