ASTM-D3354 2011

$35.75

D3354-11 Standard Test Method for Blocking Load of Plastic Film by the Parallel Plate Method

Published By	Publication Date	Number of Pages
ASTM	2011	3

Guaranteed Safe Checkout

Categories: 83.140.10 - Films and sheets, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method yields quantitative information regarding the degree of blocking (unwanted adhesion) existing between layers of plastic film. It is not intended to measure susceptibility to blocking.

1.2 By this procedure, the film-to-film adhesion, expressed as a blocking load in grams, will cause two layers of film with an area of contact of 100 cm ² to separate. The test method is limited to a maximum load of 200 g.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1This test method is similar to ISO 11502 Method B, but is not technically equivalent.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use Apparatus
2	Test Specimens Conditioning Procedure A—Constant-Rate-of-Load Device Procedure B—Constant-Rate-of-Separation Device FIG. 1
3	Report Precision and Bias Keywords TABLE 1

Additional information

Standard Title	D3354-11 Standard Test Method for Blocking Load of Plastic Film by the Parallel Plate Method
Published Code	ASTM
Publication Date	2011
Pages Count	3
ICS Codes	83.140.10 - Films and sheets

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D3354 2011

PDF Catalog

Related products