Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
AS 2129:2000 (R2016)

AS 2129:2000 (R2016)

$49.40

Flanges for pipes, valves and fittings

Published By Publication Date Number of Pages
AS 2000-01-17 57
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Specifies requirements and dimensions for circular, plate blank, boss, integrally cast or forged and welding-neck type flanges or nominal sizes DN 15 to DN 3000 and their bolting for use on pipes, valves and fittings and other pressure-retaining equipment containing fluid at pressures up to 19300 kPa and at temperatures in the range -200°C to 525°C. Flanges in carbon steel, carbon-manganese steel, low-alloy steel, stainless steel, grey iron, malleable iron, ductile cast iron or copper alloy, together with relevant material specifications are included. This Standard is applicable to flanges for water, steam, compressed air, chemical and petroleum plants, hydraulic piping and where other Standards require compliance with this Standard. Recommendations on the selection of bolting and method of making flanged joints are included. This Standard is not intended to apply to flanges for water or waste water covered by AS 4087.

Scope

This Standard specifies requirements for circular flanges of nominal sizes DN 15 to DN 3000, inclusive, and their bolting for use on pipes, valves, fittings and other pressure-retaining equipment containing fluid at pressures up to 19 300 kPa and at temperatures in the range -200°C to 525°C.

These flanges are manufactured from carbon steel, carbon-manganese steel, alloy steel, stainless steel, grey iron, malleable iron, ductile cast iron*, or copper alloy.

This Standard is applicable to flanges for water, steam, compressed air, chemical and petroleum plants, hydraulic piping and where other Standards require compliance with this Standard.

This Standard is not intended to apply to flanges for water or waste water covered by AS 4087.

Flanges R, S and T are designated obsolescent and are not recommended for use in new equipment. They are retained to provide for the servicing of existing equipment that is expected to have a long working life. For new equipment, flanges R, S and T should be replaced with flanges to AS/NZS 4331, Parts 1 to 3, ANSI B16.5 or BS 4504 (series).

The history of AS 2129 flanges (and its predecessor BS 10) and the future use of these flanges is given in the Preface.

Related products

AS 2129:2000 (R2016)
$49.40